VEGA VEGADIF 55 4 … 20 mA_HART - Manual (Page 44)

M ove with "+" or "-" to the option "Confirm". Active selection is
highlighted in black.
A ssign value (400 mbar) to the parameter "GET URV" value
(400 mbar) with the key "E". The instrument confirms the adjustment
and jumps back to the parameter, here "GET URV" (see next
illustration).
M ove to the next parameter with "E".
6 .6 Data memory module (optional)
T
he data memory is a memory module that is plugged to the
electronics module and fulfils the following functions:
l B ackup of the configuration data
l C
opy the configuration data of a transmitter to another transmitter
l C yclical recording of pressure and sensor temperature measured
values
l R ecording of various events such as e.g. alarm messages,
configuration changes, counter for exceeding and decreasing of
the measuring range for pressure and temperature, exceeding and
decreasing of the user limits for pressure and temperature etc.
Warning:
W
arning! Remove or plug data memory only in idle condition from the
electronics module.
Information:
T
he data memory module can be retrofitted any time. After having
plugged to the electronics module and the instrument is powered
again, the data in the data memory module and in the instrument are
checked. The following messages can be displayed "W702, Histo-
ROM data not consistent"
and "W706, Configuration in HistoROM and
device not identical". F or measures see Additional instructions manual
" Service instructions VEGADIF 55", "Messages".
44 VEGADIF 55 • 4 … 20 mA/HART
6 O peration
31731
-EN
-081119