VEGA VEGACOM 558 Ethernet - Manual (Page 34)

34 VEGACOM 558 Ethernet
VEGACOM 558 as web server
The html file is configured such that all existing measurement loops,
sorted according to measurement loop names, are automatically dis-
played (splitting in several pages, switching over via the navigation
board below the measured value tables). By clicking the link Measured
values (No.) the measurement loops will be sorted according to the
number of the DCS output. The html file, however, is not accessible and
cannot be modified.
In addition, it is possible to make different VEGACOM settings and
modifications with the browser on the predefined web pages. For this
purpose, you will find links on the web page which will pass you on to
the appropriate page. For this purpose, the web page is provided with
links leading you the the respective page. These links are not visible on
the start page. The corresponding authorisation level of the user can be
released with "Release settings". Acc. to the factory setting, first of all
each user has access. First of all, everybody can access this function
by factory setting. By activating the user management, access can be
avoided (see chapter "User administration").
- network settings (host name, modification of the IP address,
subnetwork masks and Name-Server addresses)
- web server (updating intervals of the web pages, selection of differ-
ent web pages)
- setup mail server
- definition of the email messages (recipient, documents, transmitting
times)
- title of web pages, date and time in VEGACOM 558 (important for
time-controlled emails)
- language used by VEGACOM 558 (German or English)
- user management.
Links
Note:
Some Internet browsers use the setting
"Use temporary internet files". This
causes the browser to read the file,
once it has been loaded, again and
again from the local hard drive. This
setting should be changed to ensure
that the HTML pages are always up-to-
date when calling up measured values
or the configuration pages of
VEGACOM.