TROY Group MICR_IRD 9050 Security Printing Solutions User’s Guide - Manual (Page 106)

Section 6 Using the Printer Control Panel
Security Printing Solutions User’s Guide -- Document #50-70410-001 Rev. D
6-8
Using the
Exact
Positioning
Technology
(cont.) T O ADJUST THE POSITION OF THE MICR LINE
1. If not already logged into the printer control panel, enter a valid administrator password ( see page 6-2 ).
2. Press the W button to select TROY MENUS
, and then press the button.
3. Press the W button to select SETTINGS MENU , and then press the button.
4. Press the W button to select the desired adjustment parameter ( MICR ADJUST X DECIPOINTS or MICR ADJUST Y
DECIPOINTS
), and then press the button.
5. Enter the desired decipoint offset value (-720 to +720) to reposition the MICR line (X=horizontal and
Y=vertical), and then press the button to save each decipoint value. Each decipoint is equal to 1/720th of
an inch. Repeat this step for each parameter you wish to change.
6. Press the W button to select AUTO ROTATION
, and then press the button.
7. Press the W button to select ENABLE or DISABLE
, and then press the button to save this setting. If enabled, the
page will print upside down (180-degree rotation) from the currently defined orientation.
8. Print a test page to evaluate the MICR line position adjustment. Repeat the adjustment as necessary. Use the
TROY MICR Document Template to verify all MICR line adjustments.
The “MICR Adjust X” selection on the printer control panel will move
the MICR line left (negative decipoints) and right (positive decipoints).
1235303 7890 1234 567 890123 56 1235303
The “MICR Adjust Y” selection on the printer control panel will move
the MICR line up (negative decipoints) and down (positive decipoints).
Negative decipoints (move left)
0
Positive decipoints (move right)
Negative decipoints (move up)
Positive decipoints (move down)