Ohaus CT Series ELECTRONIC BALANCE User Manual
Page 86
6
Sets all balance menu selections to the factory defaults.
P
P
P
P
P
Print display data in the following format:
1 2 3 4 5 6 7 8 9 10 11 12 13 14
+ display value Sp units ? Cr Lf
Sp=Space
?
?
?
?
?
Print display Unit in the following format:
(field) units stability Cr
Lf
(# of char) 3
1
1
1
M
M
M
M
M
This command has the same effect as pressing the left button (OFF
MODE) on the front panel.
T
T
T
T
T
This command has the same effect as pressing the Right button (On
TARE) on the front panel.
E
E
E
E
E
Exit parts counting mode.
L*
L*
L*
L*
L*
Start a 3 point Linearity Calibration.
C*
C*
C*
C*
C*
Start Span Calibration.
V
V
V
V
V
Print software version in the format: "CT V-.-".
N
N
N
N
N
Toggle automatic error message printing ON or OFF. Current status
after executing the command is shown as ON or OFF. Default is ON.
0D/1D
0D/1D
0D/1D
0D/1D
0D/1D
Disable/Enable a 1 second delay in the balance's response to a "P"
command.
0S/1S
0S/1S
0S/1S
0S/1S
0S/1S *
Disable/Enable the Stable Data Only printing feature. This is equiva-
lent to the StAbL sub-menu of the Print menu.
nZ*, n=0,1,2,3
nZ*, n=0,1,2,3
nZ*, n=0,1,2,3
nZ*, n=0,1,2,3
nZ*, n=0,1,2,3
Set Auto Zero Tracking to OFF, .5d, 1d or 3d. This is the equivalent
to the Auto.0 sub-menu of the Setup menu.
nnA
nnA
nnA
nnA
nnA
Set Auto Print feature to nn. This is equivalent to the Auto.P sub-menu
of the Print menu with the feature of "Interval Print" added.
nn=0, Off
nn=S, On Stable
nn=C, Continuous
nn=1 -99, Set interval to nn seconds.
Command
Command
Command
Command
Command
Character
Character
Character
Character
Character
Description
Description
Description
Description
Description
RS232 COMMAND TABLE
RS232 COMMAND TABLE
RS232 COMMAND TABLE
RS232 COMMAND TABLE
RS232 COMMAND TABLE
Only the characters shown in the following table are acknowledged by the balance. Any other
commands not shown in the table, balance responds with ES syntax error. Commands sent to
the balance must be terminated with a carriage return (CR) or carriage return-line line feed
(CRLF). Data output by the balance is always terminated with a carriage return - line feed (CRLF).
* Command is not available on Legal for Trade models.