Pin connector – Ohaus CT Series ELECTRONIC BALANCE User Manual

Page 34

tor assembly in the balance so that
the 9-pin connector fits through the
hole.

Fasten the assembly using the two

scriptions for the connector.

The balance will not output any informa-
tion unless pin 5 (CTS) is held in an ON
state (+3 to +15 VDC). Interfaces not
utilizing the CTS handshake may tie pin
5 to pin 6 to defeat it.

NOTE:

NOTE: This interface does not strictly
adhere to the official RS-232 standard
(particularly in the connector used). How-
ever, it is compatible with what is com-
monplace in the microcomputer indus-
try.

screws provided.

Slide the ribbon connector onto the

edge of the main circuit board as
shown in the diagram.

Replace the bottom plate and install

the batteries or AC Adapter. Re-
place the pan if it was removed.

9-PIN CONNECTOR

The balance can now be interfaced with
other equipment utilizing the 9-pin con-
nector which has been installed. The
diagram shows the pin-out and pin de-