Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 40)

9
BY COMPUTER DESCRIPTION BALANCE RESPONSE
nnA Set Auto Print Set the Auto Print Interval to “nn” seconds
Interval (nn = 0 to 99). Setting the interval to 00
disables the Auto Print function.
* 0Z Turn OFF Auto Zero Disables the Auto Zero Tracking feature
Tracking
(see Setup Menu in CT Series Manual).
* 1Z Turn ON Auto Zero Enables the Auto Zero Tracking feature
Tracking (see Setup Menu in CT Series Manual).
** V Print PROM Causes the balance to respond with the
Revision Level revision level of the PROM installed in the
balance. Output is in the format: “CT V_._”.
** N Disable Automatic Permits you to disable the automatic printing
Error Message of error messages output by the balance.
Printing This command is reset on power-off.
** D Revert to Factory Sets all balance menu selections to the
Default Settings following factory defaults:
All available units enabled
Default units = Grams
* Auto-Zero Tracking is ON
High Speed Display Update is OFF
* Custom Unit = Carats
* Custom Unit Conversion Factor is set to:
1.0000, LSD = 1, Exponent = 0
“Stable Data Only” printing is ON
Auto Print feature is OFF
* Does not apply to Legal For Trade models.
** Available only on balances with version 2.0 software or later.
RS-232 Error Messages RS-232 Error Messages RS-232 Error Messages RS-232 Error Messages RS-232 Error Messages
If the balance is in an error condition when a request for output occurs, the current error
message number (Err0 - Err6) will be sent in the following format:
(Field) Error # CR LF
(# of Chars.) 5 1 1