Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 62)

21
SETUP MENU SETUP MENU SETUP MENU SETUP MENU SETUP MENU
FACTORY SETTINGS FACTORY SETTINGS FACTORY SETTINGS FACTORY SETTINGS FACTORY SETTINGS
Unit Selection g
Averaging Level 1
Stability 1d
Auto Zero .5d
Conversion Factor
Mantissa 1.0000
Exponent 0
LSD 1
PC Error Level OFF
Auto Off OFF
Accessing the Setup Menu Accessing the Setup Menu Accessing the Setup Menu Accessing the Setup Menu Accessing the Setup Menu
To access the Setup menu, press and hold
until SETUP is displayed, then re-
lease.
To access a submenu:
1. Repeatedly press until the de-
sired submenu is displayed.
2. Press to select the displayed
submenu.
NOTE: NOTE: NOTE: NOTE: NOTE: You must use END to store any
changes you make to the Setup menu.
The following sections describe each item
on the Setup menu in detail.
Reset to Factory Settings Reset to Factory Settings Reset to Factory Settings Reset to Factory Settings Reset to Factory Settings
This submenu enables you to reset all
Setup menu selections to the original fac-
tory settings outlined in the adjacent table.
To reset to factory settings:
1. Access the Reset submenu.
2. Press to enter RESET.
3. Press repeatedly to change the
setting from YES to NO. Selecting
YES resets the Setup menu to the
original factory settings.
4. Press to accept the displayed
setting.