Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 37)

6
Auto Print Interval Auto Print Interval Auto Print Interval Auto Print Interval Auto Print Interval
The Auto Print feature enables the scale to automatically send displayed data to a printer
or computer, at a specified time interval. The interval can be set from 1 to 99 seconds.
Setting the interval to 0 disables the Auto Print feature. Use the following procedure to
set the Auto Print interval:
1. Access the Auto Print selection. When the TARE button is released, the current
Auto Print interval will be displayed. The number is preceded by the letters “A.P.”
2. Press the UNITS button repeatedly to increase the setting. Holding the UNITS
button down will cause the value to increase more rapidly.
3. Press the TARE button to select the displayed value.
When the TARE button is released, “A.P.” will be displayed and the Print submenu
will be returned.
Print Stable Data Only Print Stable Data Only Print Stable Data Only Print Stable Data Only Print Stable Data Only
When enabled, this feature restricts the balance to sending only stable display data
when requested. (Display data is stable when the Unit Indicator is shown in the Display.)
To turn this feature ON or OFF:
1. Access the Stable Data selection. When the TARE button is released, the current
status will be displayed.
2. Press the UNITS button to switch the status ON or OFF as desired.
3. Press the TARE button to select the displayed status.
When the TARE button is released, “Stb.” will be displayed and the Print submenu
will be returned.
NOTE: NOTE: NOTE: NOTE: NOTE: On Legal for Trade models, “Stb.” does not appear. The feature is always ON.
Exit Print Submenu Exit Print Submenu Exit Print Submenu Exit Print Submenu Exit Print Submenu
When you are finished making your selections, “End” must be used to exit the Print
submenu. Use the following procedure:
1. Access the “End” selection. When the TARE button is released, “Print” will be
displayed and the Setup Menu will be returned.
2. Press the UNITS button repeatedly until End is displayed on the Setup Menu.
3. Press the TARE button to exit the Setup Menu and save your selections.