Ohaus CT Series ELECTRONIC BALANCE User Manual

Page 66

Set the value of all digits in the same

manner.

After the last digit is entered, the dis-

play will show the current exponent.

The exponent is shown on the display

preceded by the letter E.

There are 7 exponent values which you
can choose from (see table).

Press

to change the exponent.

Press

to accept the displayed

exponent. When

is released,

the display will show the current least

significant digit.

The least significant digit is the digit in the
last decimal place on the display. The
selection you make causes the balance to
count by 1’s, 2’s or 5’s in this position.
There are 7 LSD settings you can choose
from (see table).

Press

to change the LSD.

10. Press

to accept the displayed

LSD. When

is released, C.Unit

will be displayed again and the

Setup menu will be returned.

11. Proceed to the next item on the Setup

menu or use END to exit the Setup

menu and save your selections.

EXPONENTS

E-3

Moves decimal point 3
places to the left.

E-2

Moves decimal point 2
places to the left.

E-1

Moves decimal point 1
place to the left.

Leaves decimal point in

Leaves decimal point in
normal position.

normal position.

Moves decimal point 1
place to the right.

Moves decimal point 2
places to the right.

Moves decimal point 3
places to the right.

LSD’s

LSD .1

*Adds one decimal place
and Display counts by 1’s.

LSD .2

*Adds one decimal place
and Displayby counts by
2’s.

LSD.5

*Adds one decimal place
display counts by 5’s.

LSD 1

Display counts by 1’s.

Display counts by 1’s.
(Normal Setting)

(Normal Setting)

LSD 2

Display counts by 2’s.

LSD 5

Display counts by 5’s.

LSD 10

Removes last decimal
place and Display counts
by 1’s.

* Sensitivity to vibration is increased

with this LSD setting.