Ohaus CT Series ELECTRONIC BALANCE - Manual (Page 56)

15
USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE
The following illustration identifies the items in each menu and the factory default
settings are shown in bold type.
SETUP
RESET
Yes,No
UNIT SELECTION
g g g g g, oz, oz t, dwt, lb,
t, • (custom), PC
DFLT/USR
AVERAGING LEVEL
0, 1 1 1 1 1, 2
STABILITY
.5d, 1d 1d 1d 1d 1d, 2d, 5d
AUTO ZERO
OFF, .5d .5d .5d .5d .5d, 1d,
3d
CUSTOM UNIT
CONVERSION
FACTOR
Mantissa
1.0000 1.0000 1.0000 1.0000 1.0000
Exponent
E0 E0 E0 E0 E0,E1, E2,E3,
E -3,E -2, E-1
LSD
.1d, .2d, .5d, 1d 1d 1d 1d 1d,
2d, 5d, 10d
PARTS COUNTING
ERROR LEVEL
OFF OFF OFF OFF OFF, 1, 2.5, 5
AUTO OFF
OFF OFF OFF OFF OFF, 60, 120, 180
END
CAL
SPAN
LINEARITY
END
PRINT
NOTE: Refer to instructions
provided with the optional
RS232 interface kit.
To access a menu, press and hold until desired menu appears, then release it.
Use these buttons to step through menus and select submenus:
next
selection
select
displayed item