M&C TechGroup PMA 20 Operator's manual - Manual (Page 5)

5
Gas sampling and gas conditioning technology 9-3.5.1-ME
3 SAFETY INSTRUCTIONS
Please take care of the following basic safety procedures when mounting, starting up or
operating this equipment:
Read this operating manual before starting up and use of the equipment. The information and
warnings given in this operating manual must be heeded.
Any work on electrical equipment is only to be carried out by trained specialists as per the reg u-
lations currently in force.
Attention must be paid to the requirements of VDE 0100 (IEC 364) when setting high -power elec-
trical units with nominal voltages of up to 1000 V, together with the associated standards and
stipulations.
Check the details on the type plate to ensure that the equipment is connected to the correct
mains voltage.
Protection against touching dangerously high electrical voltages:
Before opening the equipment, it must be switched off and hold no voltages. This also applies to
any external control circuits that are connected.
The device is only to be used within the permitted range of temperatures and pressures.
Check that the location is weather-protected. It should not be subject to either direct rain or
moisture.
The device must not be used in hazardous areas.
Installation, maintenance, monitoring and any repairs may only be done by authorized personnel
with respect to the relevant stipulations.
4 WARRANTY
If the equipment fails, please contact M&C directly or else go via your appointed M&C dealer.
We offer a one year warranty as of the day of delivery as per our normal terms and conditions of
sale and assuming technically correct operation of the device. Consumables are hereby ex-
cluded. The terms of the warranty cover repair at the factory at no cost or the replacement at no
cost of the equipment free ex user location. Reshipments must be sent in a sufficient and proper
protective packaging.