M&C TechGroup MP47_D Operator's manual - Manual (Page 13)

13
Gas sampling and gas conditioning technology 6-1.1.1-ME
14 INSTALLATION INSTRUCTIONS
When installing the pump make certain that accident prevention regulations and safety instructions
including those for subsequent operation are observed. The safety instructions in section 6.2 must be
observed.
N O T E !
The pump must only be used in the conditions specified in the
technical data. The pump should be installed away from heat
sources and freely ventilated to prevent any accumulation of heat.
For outdoor installation, the pump must be installed in a housing
protected from frost in the winter and sufficiently ventilated in
summer. Exposure to direct sunlight must be avoided.
The protection class of the pumps MP47, MP47-Z, MP47/R, MP47-Z/R, MP47D is IP20 and so offer
no protection against contact or foreign bodies.
W A R N I N G !
It is therefore essential to provide protection for persons against
contact with live parts (e.g. electrical connections, motor windings)
and moving parts (e.g. fan). Protection against the entry of foreign
bodies must also be provided.
N O T E !
Pumps have mechanical moving parts that can induce vibrations.
To prevent damages at the pump or at peripheral components /
facilities as well as minimizing noise development an appropriate
vibration decoupling is necessary. For this M&C can deliver e.g.
anti-vibration pads.
This explicit is also valid for the connection of the sample lines at
the pump head.
14.1 MECHANICAL

The dimensions of the mountings are given in figure 7 and figure 8.

The pump is provided for assembly and therefore it has to be fastened with screws.

Install the pump so that the fan can draw in sufficient cooling air.

Install the pump so that accidental finger contact with the fan is impossible.

Mounting the pump at the highest place in system and/or with pump head downside so that
condensate cannot be assembled inside the head.