M&C TechGroup MP47_D Operator's manual - Manual (Page 12)

12
Gas sampling and gas conditioning technology 6-1.1.1-ME
12 FLOW SENSOR LPH 125-1-A-SPST INCL. CONNECTION SET MP47 .../D
MOUNTED ON PUMP MP47 .../D
The optional available flow sensor LPH is provided with a mounting clip, 2x male connectors 1/8”- 2
mm and 0,5 m PTFE tube 1 x 2 mm.
ø 28
51
Figure 6 Pump MP47 .../D with flow sensor
Fitting position: vertical
Alarm level: 7 l/hr
Switching function: NC or NO depending on mounting position
NC = lead of flow sensor in position at the top
Contact rating: DC max. 200 V, 50 W, 1 A; AC max. 150 V, 70 VA, 0,7 A
Material: Acrylic, PTFE, nickel-plate brass
As monitoring gas, it can be used N
2
or with max. 1,7 bar,
depending on the application (at least, however, sample pressure plus 0,2 bar compressed air).
In case of a correctly functioning diaphragm pump, no monitoring gas will be consumed.
13 RECEIPT OF GOODS AND STORAGE

Please take the sample pump and possible special accessories carefully out of the packaging
material immediately after arrival, and compare the goods with the items listed on the delivery
note!

Check the goods for any damage caused during delivery and, if necessary, notify your trans-
port insurance company without delay of any damage discovered.
N O T E !
The equipment should be stored in a protected, frost-free room!
LPH-7 l/hr
1/8“ NPT f