M&C TechGroup FSS-..._H350 Operator's manual - Manual (Page 8)

8
Gas sampling and gas conditioning technology 5-2.1.5-ME
9 DESCRIPTION
The M&C filter FSS../H350 is mounted thermally isolated on a plate. The stainless steel filter body with
integrated filter element, alternatively of ceramic, stainless steel or special spun glass, is completely
covered by a heated metal enclosure.
The high capacity heating element is controlled by an incorporated compact capillary sensor
thermostat in a temperature range of +50 °C to 350 °C. The thermostat is equipped with an
temperature limiter switch with reset key, releasing at 30 °C above set-temperature, and a voltage-free
low temperature alarm contact at 30 °C below set-temperature. In order to avoid cold spots, the
welded connecting fittings are heated up with the filter by means of two heat conducting jaws.
Outside the lagged cap a junction box is mounted which contains the thermostat as well as the
terminals for electrical connection. Two brackets fix the heated lines. The complete conception
guarantees a safe operation and a simple maintenance. No tools are needed for replacing the filter
element, during the heated sample lines remain in their position.
Figure 1 Electrical heated universal filter FSS-../H350
10 RECEPTION AND STORAGE
The device is a complete pre-installed unit.

Carefully inspect the device and any special accessories included with it immediately on arrival
by removing them from the packing and checking for missing articles against the packing list!

Check the items for any damage in transit and, if required, inform the shipping insurance
company immediately of the damage found!
C A R E !
The device must be stored in a weather protected frost-free area!
Filter element Junction box
with thermostat Connecting
fittings
Heat
conducting
jaws
Lagged cap
Brackets
Alarm-
contact
Power
Sample IN
Sample OUT