EVS XTnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 48)

Exit
When exiting Multicam, a warning will appear to remind the operator that one disk was
disconnected, and invite him to perform a hardware check to repair the video raid. This is
displayed even if a spare disk is available:
• if the faulty disk is a spare disk:
"Warning: a spare disk has been disconnected. At the next
opportunity please consider replacing the faulty disk. It can
be identified in the Shift-F5 screen or in the EVS - RAID
configuration menu. [Enter]=Continue"
• if the faulty disk is contained in a RAID:
"Warning: a disk has been disconnected. At the next opportunity
please consider replacing the faulty disk. It can be identified
in the Shift-F5 screen or in the EVS - RAID configuration menu.
[Enter]=Continue"
Restarting
If Multicam is restarted without the RAID being rebuilt, a message similar to the following
one, and adapted to the disk type, is displayed during the bootwins:
• if a spare disk is OK:
[ Bad ] SEAGATE ST9300603SS 3SE10H1J 0006 279GB 02 07
• if no spare disk is OK and the RAID is no more complete:
[ Bad ] SEAGATE ST9300603SS 3SE10H1J 0006 279GB 02 07
WARNING !!! Tray XX is missing 1 disk(s) to be complete
Then when entering Multicam, another message appears, even if a spare disk is available:
• if the faulty disk is a spare disk:
"Warning: a spare disk has been disconnected. The system will
operate normally on the remaining disks. At the next
opportunity please consider replacing the faulty disk. It can
be identified in the Shift-F5 screen or in the EVS - RAID
configuration menu. [Enter]=Continue"
• if the faulty disk is contained in a RAID:
"Warning: a disk has been disconnected. The system will operate
normally on the remaining disks. At the next opportunity please
consider replacing the faulty disk. It can be identified in the
Shift-F5 screen or in the EVS - RAID configuration menu.
[Enter]=Continue"
The operator can press ENTER and operate normally on 4 disks (configuration “4+1”) or
on 5 disks (configuration “5+1”) or exit the software and return to Multicam Setup window
to run a hardware check.
XTnano Server - Version 11.01 - Configuration Manual
2. Multicam Setup 38