Starting the evs server, Documented user interfaces, Configuration manual structure – EVS XTnano Version 11.01 - November 2012 Configuration Manual User Manual
Page 14: Introduction, When starting the evs server for the first time
Documented User Interfaces
The Server Configuration manual deals with all user interfaces used to configure
Multicam: server-based application, web-based interface, and Remote Panel.
•
On the one hand, the information on navigability and editing commands, specific to the
user interface, is described in clearly separated sections.
•
On the other hand, the reference information on and the description of configuration
parameters are described in common sections valid for all user interfaces. A clear
overview shows whether and where the parameters are available in each user
interface.
Configuration Manual Structure
The Server Configuration manual is organized in two sections:
•
A section dedicated to the Multicam Setup window that mainly features:
◦
the configurations lines and their management
◦
the functions related to server administration and maintenance.
•
A section dedicated to the Multicam Configuration window, organized in seven tabs,
which describes all server configuration parameters that can be defined for each
configuration line. The section includes:
◦
the parameter description itself
◦
other server-related information needed for the configuration
1.3.
Starting the EVS Server
Introduction
When switching on the EVS server, the first step is the PC boot sequence, followed by
the boot of the video I/O boards, and finally the Multicam Setup application is started.
When Starting the EVS Server for the First Time
Before you first use your EVS server, you need to perform the following tasks:
•
Define the configuration lines your EVS server should run.
For more information, see section "Configuration Lines" on page 11.
•
Define the configuration parameters for each configuration line you will need.
In this step, you will define, among others, the channel configuration for the selected
configuration line, as well as audio and video parameters for the EVS server.
For more information, see section "Multicam Configuration" on page 42.
4
1. Introduction
EVS Broadcast Equipment S.A. - November 2012
Issue 11.01.A