ZyXEL Communications Prestige P-870HW-51a v2 - Manual (Page 56)

Chapter 5 WAN Setup
P-870HW-51a v2 User’s Guide
56
5.4.1 Advanced Internet Connection Setup
Use this screen to edit your ZyXEL Device's advanced WAN settings. Click the
Advanced Setup button in the Internet Connection screen. The screen
appears as shown.
Figure 28 WAN > Internet Connection: Advanced Setup
The following table describes the labels in this screen.
Table 10 WAN > Internet Connection: Advanced Setup
LABEL DESCRIPTION
RIP & Multicast
Setup This section is not available when you configure the ZyXEL Device to be
in bridge mode.
RIP Version RIP (Routing Information Protocol) allows a router to exchange routing
information with other routers.
This field is available only when you select ENET ENCAP.
This shows the RIP version used for this WAN connection.
RIP
Operation
This field is available only when you select ENET ENCAP.
This shows whether RIP is enabled (Active) or not (Disable) on this
WAN connection.
IGMP
Multicast
Multicast packets are sent to a group of computers on the LAN and are
an alternative to unicast packets (packets sent to one computer) and
broadcast packets (packets sent to every computer).
IGMP (Internet Group Multicast Protocol) is a network-layer protocol
used to establish membership in a multicast group. The ZyXEL Device
supports both IGMP version 1 and version 2. Select Enable to turn on
IGMP. Otherwise, select Disable.