ZyXEL Communications Prestige P-870HW-51a v2 - Manual (Page 126)

Chapter 10 Static Route
P-870HW-51a v2 User’s Guide
126
10.2 The Static Route Screen
Click Advanced > Static Route to open the Static Route screen.
Figure 61 Advanced > Static Route
The following table describes the labels in this screen.
Table 35 Advanced > Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Active This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
Destination This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
Netmask This parameter specifies the IP network subnet mask of the final
destination.
Gateway This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Interface This is the WAN interface through which the traffic is routed.
Remove Click the icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
Add Click this to create a new rule.
Apply Click this to apply your changes to the ZyXEL Device.