ZyXEL Communications Prestige P-870HW-51a v2 - Manual (Page 127)

Chapter 10 Static Route
P-870HW-51a v2 User’s Guide
127
10.2.1 Static Route Edit
Click the Add button in the Static Route screen. Use this screen to configure the
required information for a static route.
Figure 62 Static Route: Add
The following table describes the labels in this screen.
Table 36 Static Route: Add
LABEL DESCRIPTION
Destination IP
Address This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
IP Subnet
Mask Enter the IP subnet mask here.
Use Interface Select a WAN interface through which the traffic is sent. You must have
the WAN interface(s) already configured in the WAN screens. If you
select a WAN interface using ENET ENCAP you must specify the gateway
IP address.
Use Gateway
IP Address Select this option and enter the IP address of the next-hop gateway. The
gateway is a router or switch on the same segment as your ZyXEL
Device's interface(s). The gateway helps forward packets to their
destinations.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.