ZyXEL Communications Prestige P-870HW-51a v2 - Manual (Page 137)

Chapter 11 Quality of Service (QoS)
P-870HW-51a v2 User’s Guide
137
11.6 Technical Reference
The following section contains additional technical information about the ZyXEL
Device features described in this chapter.
MAC Mask Type the mask for the specified MAC address to determine which bits
a packet’s MAC address should match.
Enter “f” for each bit of the specified source MAC address that the
traffic’s MAC address should match. Enter “0“ for the bit(s) of the
matched traffic’s MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
You cannot put a “0” pair before an “f” pair. For example,
ff:ff:00:ff:00:00 is invalid.
Destination
Address
Enter the destination IP address in dotted decimal notation.
Subnet Mask Enter the destination subnet mask.
Port If you select a protocol type, enter the port number(s) of the
destination. 0 means any destination port number.
MAC Address Enter the destination MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits
a packet’s MAC address should match.
Enter “f” for each bit of the specified destination MAC address that the
traffic’s MAC address should match. Enter “0“ for the bit(s) of the
matched traffic’s MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
You cannot put a “0” pair before an “f” pair. For example,
ff:ff:00:ff:00:00 is invalid.
Others
Protocol
Select the protocol (service type) from TCP, UDP, ICMP or IGMP.
Differentiated
Services Code
Point (DSCP) Select a DSCP value from the drop-down list box.
default represents the default DSCP value 000000 or 0x00.
802.1p Priority Select a priority level (between 0 and 7) from the drop down list box.
"0" is the lowest priority level and "7" is the highest.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 41 QoS Class Configuration (continued)
LABEL DESCRIPTION