Troubleshooting, 1 power, hardware connections, and leds, Chapter 16 troubleshooting – ZyXEL Communications V300 User Manual
Page 147: Troubleshooting (147)
V300 User’s Guide
147
C
H A P T E R
16
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
•
Power, Hardware Connections, and LEDs
•
•
16.1 Power, Hardware Connections, and LEDs
V
The V300 does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the V300.
2 Make sure the power adaptor or cord is connected to the V300 and plugged in to an
appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the V300.
4 If the problem continues, contact the vendor.
V
One of the keys or LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the key or LED. See
2 Check the hardware connections. See the Quick Start Guide and
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the V300.
5 If the problem continues, contact the vendor.
V
I forgot the IP address for the V300.