ZyXEL Communications ZYWALL10 - Manual (Page 56)

ZyWALL 10 Internet Security Gateway
3-8 Internet Access
Use the instructions in the following table to configure IP Alias parameters.
Table 3-3 IP Alias Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Alias Choose Yes to configure the LAN network for the ZyWALL. Yes
IP Address Enter the IP address of your ZyWALL in dotted decimal notation 192.168.2.1
IP Subnet Mask Your ZyWALL will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL
255.255.255.0
RIP Direction Press the [SPACE BAR] to select the RIP direction from Both, In
Only, Out Only or None. None
Version Press the [SPACE BAR] to select the RIP version from RIP-1, RIP-
2B or RIP-2M. RIP-1
Incoming
Protocol Filters Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the ZyWALL. 1
Outgoing
Protocol Filters Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the ZyWALL. 2
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to save
your configuration, or press [ESC] at any time to cancel.
3.3 Internet Access Setup
You will see three different menu 4 screens depending on whether you chose Ethernet, PPTP or PPPoE
Encapsulation.
3.3.1 Ethernet Encapsulation
You must choose the Ethernet option when the WAN port is used as a regular Ethernet. The PPPoE choice
is for a dial-up connection using PPPoE. If you choose Ethernet in menu 4 you will see the next screen.