ZyXEL Communications ZYWALL10 - Manual (Page 47)

ZyWALL 10 Internet Security Gateway
Hardware Installation & Initial Setup 2-13
Figure 2-10 Menu 2 — WAN Setup
The MAC address field allows users to configure the WAN port's MAC address by either using the factory
default or cloning the MAC address from a computer on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
Table 2-6 WAN Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
MAC Address
Assigned By Press the [SPACE BAR] to choose either of the two methods of
assigning a MAC Address. Choose Factory Default to select the
factory assigned default MAC Address. Choose IP Address attached
on LAN to use the MAC Address of that workstation whose IP you
give in the following field. Factory
Default
IP Address This field is applicable only if you choose the IP Address attached
on LAN method. Enter the IP address of the workstation on the LAN
whose MAC you are cloning. 192.168.1.1
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
2.9 LAN Setup
This section describes how to configure the LAN using Menu 3 — LAN Setup. From the main menu, enter
3 to open menu 3.
Menu 2 - WAN Setup
MAC Address:
Assigned By=IP address attached on LAN
IP Address= 192.168.1.12
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle