Appendix e firewall cli commands – ZyXEL Communications ZYWALL10 User Manual
Page 245
ZyWALL 10 Internet Security Gateway
CLI Commands
G
Appendix E
Firewall CLI Commands
The following table describes the syntax used to configure your firewall using Command Line Interface
(CLI) commands. Select Menu 24.8 - Command Interpreter Mode from the main menu to go into CLI
mode. For details on other CLI commands to configure your ZyWALL, please consult the included disk.
Function
CLI Syntax
Description
F
F
i
i
r
r
e
e
w
w
a
a
l
l
l
l
S
S
e
e
t
t
-
-
U
U
p
p
config edit firewall active
Activates or deactivates the saved firewall settings.
config retrieve firewall
Retrieves currently saved firewall settings.
config save firewall
Saves the current firewall settings.
D
D
i
i
s
s
p
p
l
l
a
a
y
y
config display firewall
Displays the all the firewall settings including e-mail, attack,
and sets/rules.
config display firewall set
Displays current entries of a set configuration; including
timeout values, name, default-permit, and number of rules
under it.
If you don’t put # after set, it will display all the sets/rules
information.
config display firewall set
Displays current entries of a rule in a set configuration;
config display firewall attack
Displays all the settings for attack alert.
config display firewall e-mail
Displays all the setting for e-mail part.
config display firewall ?
Displays all the available sub commands.
E
E
d
d
i
i
t
t
E
E
-
-
m
m
a
a
i
i
l
l
config edit firewall e-mail mail-
server
Edits the mail server which alerting e-mail messages are
sent through.
config edit firewall e-mail
return-addr
Edits the source address for sending mail usage.