ZyXEL Communications ZYWALL10 - Manual (Page 140)

ZyWALL 10 Internet Security Gateway
Firmware and Configuration File Maintenance 10-9
COMMAND DESCRIPTION
Remote File This is the filename on the ZyWALL. The filename for the
firmware is “
ras ” and for the configuration file, is “ rom-0 ”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
TFTP over WAN will not work if:
1. You have disabled Telnet service in menu 24.11.
2. You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet service.
3. The IP you entered in the Secured Client IP field in menu 24.11 does not match the client IP. If it
does not match, the ZyWALL will disconnect the Telnet session immediately.
4. You have an SMT console session running.
5. The firewall is active. The default firewall policies block all traffic from the WAN, so to enable TFTP
over the WAN, you must turn the firewall off (menu 21.2) or create a firewall rule to allow TFTP from
the WAN.
10.6 FTP File Transfer
In addition to uploading the firmware and configuration via the console port and TFTP client, you can also
upload the ZyWALL firmware and configuration files using FTP. To use this feature, your workstation
must have an FTP client.
When you telnet into the ZyWALL, you will see the following screens for uploading firmware and the
configuration file using FTP.