ZyXEL Communications ZYWALL10 - Manual (Page 144)

ZyWALL 10 Internet Security Gateway
System Maintenance & Information 11-1
Chapter 11
System Maintenance & Information
This chapter leads you through SMT menus 24.8 to 24.11.
11.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main router firmware. The CI provides much of the same
functionality as the SMT, while adding some low-level setup and diagnostic functions. The CI can be
entered from the SMT by selecting menu 24.8. Access can be either by Telnet or by a serial connection to
the console port, although some commands are only available with a serial connection. See the included
disk or the zyxel.com web site for more detailed information on CI commands. Enter 8 from Menu 24 -
System Maintenance. A list of valid commands can be found by typing
help or ? at the command
prompt. Type “exit” to return to the SMT main menu when finished.
Figure 11-1 Command Mode in Menu 24
Figure 11-2 Valid Commands
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
Copyright (c) 1994 - 2001 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit device ether
poe config ip ppp
hdap
ras>