beautypg.com

Xerox 4512N User Manual

Page 125

background image

C l e a n i n g t h e P r i n t e r

C h a p t e r 7 : P r i n t e r M a i n t e n a n c e a n d C o n s u m a b l e s 7-11

3

Pivot the Photoconductor / Drum up toward
the front of the printer.

4

Locate the main corotron’s wire inside the slot
at the base of the raised Photoconductor /
Drum, and insert the cleaner’s red brush into

one extreme end of the slot.

The tabs above the brush on the cleaner fit
into the groove above and parallel to the

slot in the Photoconductor / Drum.

5

Draw the cleaner all the way along the main
corotron to the other end of the slot, either to
the left or the right.

Go the complete width, from one side of
the Photoconductor / Drum to the
other. Do not take the cleaner out
halfway.

6

Return the corotron cleaner to its slot at the
rear of the printer.

7

Pivot the Photoconductor / Drum gently back
into place.

8

Close the top cover, reconnect the power cord,
and power ON the printer.

This manual is related to the following products: