Xerox 4512N - Manual (Page 120)

P r i n t e r M a i n t e n a n c e a n d C o n s u m a b l e s
7-6 ❖ D o c u P r i n t 4 5 1 2 / 4 5 1 2 N U s e r G u i d e
Replacing the
Photo-
conductor /
Drum
The DocuPrint 4512’s Photoconductor / Drum will print approximately
30,000 pages of A4 or 8.5 x 11 paper under average operating
conditions (5% image area coverage). The number of prints per
Photoconductor / Drum will decrease if you routinely:
• Print dense text and graphics.
• Adjust the Print Density to a dark setting.
• Exceed five percent area coverage.
Replace the Photoconductor / Drum as soon as you see the following
message at the Control Panel display:
Drum Near End
The Supply indicator light will also glow.
Instructions begin on the next page.
Note
See Appendix A: Ordering Information for ordering a new
Photoconductor / Drum.
Caution
Do not expose the Photoconductor / Drum to direct sunlight or
artificial light for more than 15 minutes. Overexposure will
permanently damage the photosensitive imaging drum.