ZyXEL Communications P-2602H - Manual (Page 98)

Chapter 7 WAN Setup
P-2602H(W)(L)-DxA User’s Guide
98
7.5 Internet Access Setup
Use this screen to change your ZyXEL Device’s WAN remote node settings. Click Network >
WAN > Internet Access Setup. The screen differs by the encapsulation you select.
See
Section 7.1 on page 93 for more information.
Figure 48 Internet Access Setup (PPPoE)
The following table describes the labels in this screen.
Table 22 Internet Access Setup
LABEL DESCRIPTION
General
Mode Select Routing (default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list
box. Choices vary depending on the mode you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your
ISP assigned. If assigned a name in the form user@domain where domain
identifies a service name, then enter both components exactly as given.
Password (PPPoA and PPPoE encapsulation only) Enter the password associated with the
user name above.
Service Name (PPPoE only) Type the name of your PPPoE service here.