Xerox 8290 - Manual (Page 60)

4 Printer Operation
52 8265/8290/8365/8390 User Guide
4.3.1.20 TopFeed Menu
Set the amount of media to be fed when printing begins. Make this setting when using roll media.
Setup items Parameters Description
TopFeed <0mm>-400mm To feed media at the start of printing. Set when
printing on roll media.
• [F2] key: to increase the setup value.
• [F4] key: to decrease the setup value.
• [ENTER] key: to confirm the setup value
• [CANCEL] key: to cancel the setup value
4.3.1.21 MediaCut Menu
Set media cut method after printing.
Setup items Parameters Description
Auto After printing has been completed, the media is sent to the media cut
position and is automatically cut.
Manual Feed media to the media cut position after printing.
Use regular cutting blades available from hardware stores.
Off No media feed after printing.
Media cutting
- When "Auto" is selected, proceed to the Shortest Cut Length menu.
• If "Manual" or "Off" has been selected, the screen changes to the menu
of the previous hierarchy.
Notes
• For the situations shown below, the media cut settings are always changed to "Off" regardless the
previous settings.
o
When "Take-up system" or “Roll-up/roll off system” is set for the media detection settings (Media
detection menu)
• When using the media shown below, set the media cut setting to "Manual". If set to "Auto", the
following errors may occur :
o
Cloth material: The cloth fibre is not completely cut.
o
Media with glue: Glue will adhere to the cutting blade and decrease cutting performance.