Xerox Phaser Color Printer 8400 - Manual (Page 22)

Printer Settings
Phaser® 8400 Color Printer
1-15
Printing the Startup Page
To print the “Startup Page”:
1. Select Information , then press the OK button.
2. Select Information Pages , then press the OK button.
3. Select Startup Page , then press the OK button to print.
Accessing Power Saver
To save energy, the printer enters a Power Saver, low-energy consumption mode after a pre-
defined period of time since its last activity. In this mode, most printer electrical systems are
shut down. When a print job is sent to the printer, the printer enters Warmup Mode. You can
also warm up the printer by pressing the OK button on the front panel.
If you find that the printer is going into Power Saver mode too often and you do not want to
wait while the printer warms up, increase the length of time before the printer goes into Power
Saver mode. Change the timeout value as follows:
1. At the printer’s front panel, select Printer Setup , then press the OK button.
2. Select Printer Controls , then press the OK button.
3. Select Power Saver Timeout , then press the OK button.
4. Press the Down Arrow or Up Arrow button to scroll to a selected Power Saver timeout
value. Select a larger value if you want to extend the length of time before the printer goes
into Power Saver mode.
5. Press the OK button.
Accessing Intelligent Ready Mode
Intelligent Ready mode is an automated system that:
■ Monitors the printer’s usage.
■ Warms up the printer when you are most likely to need it based on past usage patterns.
To turn on/off the Intelligent Ready mode, use either:
■ The printer’s front panel
■ CenterWare IS
Using the Printer’s Front Panel
To turn Intelligent Ready mode on/off:
1. Select Printer Setup , then press the OK button.
2. Select Printer Controls , then press the OK button.
3. Select Intelligent Ready .
4. Press the OK button to turn on/off Intelligent Ready .
5. Select Exit , then press the OK button to return to the main menu.