beautypg.com

Multilink ppp, Call bumping – ZyXEL Communications omni.net Plus User Manual

Page 84

background image

Technical Reference for ZyXEL omni.net series

7-4

Compression Control AT Commands

Description

AT&K00

Disable CCP negotiation (default).

AT&K44

Enable CCP negotiation.

Table 37. Compression Control AT Commands

Multilink PPP

There are two B channels in basic rate ISDN. This offers the possibility of opening multiple

simultaneous channels between systems giving users additional bandwidth on demand. Multilink

PPP is a method for bundling both B-channels into one PPP link for higher throughput.

Multilink PPP must be negotiated in the establish-link phase by both peers. If the negotiation is

successful, the second link will be dialed after the first link reaches network phase. In some

countries the directory number is not the same for both channels. For dialing the second B-channel

with a different directory number, both numbers must be obtained before dialing out unless the peer

supports BACP/BAP, which will be described later in this chapter. Multilink PPP is described in

RFC1990.

CCP AT Commands

Description

AT&J3

Enable Multilink PPP.

ATDI[+]

Dial Multilink PPP with num1 twice or with num1 and num2 if they differ.

ATS61.3 = 0

Use rotate method to bundle both channels (default).

ATS61.3 = 1

Use split method to bundle both channels.

Table 38. CCP AT Commands

Call Bumping

You can place or answer a voice call from a device that is attached to one of the POTS ports while

Multilink PPP is active. The omni.net automatically drops one of the channels and assigns it to

voice calls. Once a voice-call ends, the omni.net automatically re-establishes the channel.

When fully disconnecting with the central switch, there is a 10-seconds time delay between

on-hook phone and channel re-establishment. During call bumping, the traffic for BOD is still

This manual is related to the following products: