ZyXEL Communications omni.net Plus - Manual (Page 165)

Technical Reference for ZyXEL omni.net series
B-13
All the Following Commands Require a 'AT' Prefix
S Com. bit dec hex Function and description +Def./Ref.
S84= bit dec hex
0-2 Embedded Protocol Analyzer control. CCn
0 1 1 Capture DTE-DCE interface protocol information.
1 2 2 Capture B-channel (X.75 or V.120) frames.
2 4 4 Capture D-channel protocol information.
3 0 0 (*) Display S register value in decimal format.
8 8 Display S register value in hex format.
4 0 (*) 0 Indicate Caller ID after the 1st RING message.
16 10 Disable Caller ID indication.
5 0 0 POTS port 1 has higher priority for answering an analog call. &L0
32 20 POTS port 2 has higher priority for answering an analog call. &L1
S85= bit dec hex
0 0 0 Call Bumping function disabled. CE0
1 1 (*) Call Bumping function enabled. CE1
1-6 0 (*) Add-persist time interval. KAxn
7 0 0 (*) S85b1-6 is in Second unit. KASn
128 80 S85b1-6 is in Minute unit. KAMn
S87= bit dec hex
0 0 (*) 0 Enable POTS port 1 to receive global calls.
1 1 Disable POTS port 1 to receive global calls.
1 0 (*) 0 Enable POTS port 2 to receive global calls.
2 2 Disable POTS port 2 to receive global calls.
2 0 (*) 0 CHAP/PAP for authentication conversion.
4 4 PAP only for authentication conversion.
4 0 (*) 0 Result code 46 for X7 is CONNECT 112K/..
Result code 47 for X7 is CONNECT 128K/..
16 10 Result code 46 for X7 is CONNECT 112000/..
Result code 47 for X7 is CONNECT 128000/..
5-6 0 (*) 0 Bundle connection is disabled. &Jn