ZyXEL Communications omni.net Plus - Manual (Page 154)

Technical Reference for ZyXEL omni.net series
B-2
To view all of the S-register settings use the '&Vn' AT command:
# AT&Vn
The following table summarizes the S-register viewing commands.
S-register Viewing AT
Commands
Description
ATSr r=0-124 Display the value stored in S-register 'r'.
AT&Vn n=0-7 View all of the S-register settings.
&V0 View S-register settings for current active profile.
&V1 to &V4 View settings for user profile number (n-1).
&V5 View the factory set default settings.
&V6 View the POTS port 1 setting, Phone 1. (for omni.net LCD/Plus).
&V7 View the POTS port 2 setting, Phone 2. (for omni.net LCD/Plus).
Note: The S-register values may be displayed in either Decimal or Hexadecimal format when using the
preceding commands. Bit 3 of S-register 84 sets which numbering system is used for display.
ATS84b3=0 Display in decimal format.
ATS84b3=1 Display in Hex format.
For example, to display the value of bit 'm' of S-register 'r', use:
! ATSrbm?
Table 72. S-register Viewing AT Commands
Setting S-registers
In order to change the value in S-register 'r' to value 'n', use:
!
ATSr=n (range 0-255)
In order to change the value in a specific bit 'm' of S-register 'r', use:
!
ATSrbm=n (range 0-1)
In both commands, 'n' is a decimal number in the given range. While the first command modifies all