beautypg.com

Setting and modifying passwords, Modifying the supervisory password – ZyXEL Communications omni.net Plus User Manual

Page 104

background image

Technical Reference for ZyXEL omni.net series

8-16

Setting and Modifying Passwords

Up to 40 user passwords can be defined using the [AT*Hn] command, where 'n' represents the

index to the entry (n=0-39).

The corresponding 40 callback numbers are defined by [AT&Zn=xxx] command, where 'n'

represents the index to the entry, and 'xxx' represents the assigned callback phone number. Any

character (ASCII 0-127) can be used in the password table. The maximum password length is 8

characters for each entry.

Security functions are only accessible through AT commands in terminal mode.

A supervisory password is required for adding or modifying entries. The default supervisor

password is 'ZyXEL' when the omni.net is shipped from the factory. The supervisory password is

sent to the remote device if Type 1 security is set at the remote end.

Modifying the Supervisory Password

To modify the supervisor password, use [AT*HS].

The system will prompt for the original password and a new password. Then re-enter the new

password for verification. For example:

Password:

********

(Enter current supervisory password)

Password:

********

(Enter new supervisory password)

Verify:

********

(Enter the new supervisory password again)

OK

This manual is related to the following products: