2 tacacs+ server setup – ZyXEL Communications XGS-4526 User Manual
Page 227
Chapter 25 AAA
XGS-4526 User’s Guide
227
25.2.2 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See
for more information on TACACS+ servers. Click on the TACACS+
Server Setup link in the Authentication and Accounting screen to view the
screen as shown.
Figure 116 Advanced Application > AAA > TACACS+ Server Setup
Shared Secret
Specify a password (up to 32 alphanumeric characters) as the key to be
shared between the external RADIUS accounting server and the Switch.
This key is not sent over the network. This key must be the same on the
external RADIUS accounting server and the Switch.
Delete
Check this box if you want to remove an existing RADIUS accounting
server entry from the Switch. This entry is deleted when you click Apply.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 68 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
DESCRIPTION