Xerox 450c - Manual (Page 85)

85
Switching from pulse to touch-
tone dialing during
a dialing sequence
If your phone line uses pulse (rotary) dialing, you can
switch from pulse to touch-tone dialing when sending a fax.
Depending on your telephone system, you may need to use
touch-tone dialing to enter the access number for your long-
distance service.
To switch from pulse to touch-tone dialing, you need to
change the
PAUSE key setting from pause only (the
default) to dial options. This procedure describes how to
change the
PAUSE key setting.
1. At the WorkCentre 450c, press the MENU key.
2. Press 5 [Setup] and ENTER .
3. Press 7 [Control panel] and ENTER.
4. Press 4 [Pause key] and ENTER.
5. Press RIGHT ARROW to display [dial options] and
ENTER .
The WorkCentre sounds a confirmation beep.
6. Press STOP to exit the menus.