Xerox 450c - Manual (Page 234)

234
The print quality
of my
transparencies is
poor. Do one or more of the following:
1. Make sure Transparency is selected as the
Media on the Main Controls property page
(click Printer in the WorkCentre 450c Sta-
tus window to open the property page).
You also might need to use the applica-
tion’s Page Setup command to select
Transparency.
2. Check that your transparency film is loaded
properly. The end with the adhesive strip
must be loaded first.
My document
doesn’t feed into
the scanner. Remove the paper from the document tray and
fan the pages. Make sure you do not load more
than 20 pages of 16 to 24 lb paper in the tray. If
problems still occur, clean the automatic
document feed rollers.
The paper doesn’t
feed into the
printer. Remove the paper from the paper tray and fan
the pages. Make sure you do not load more
than 150 pages of 20 lb paper in the tray, and
do not load more than one type of media. If
problems still occur, clean the paper exit rollers.
Problem Solution