Zebra Technologies Z4Mplus - Manual (Page 98)

Configuration
Control Panel LCD Displays 90
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Select ZPL Mode
The printer remains in the selected mode until it is changed by this
parameter or by using a ZPL/ZPL II command. The printer accepts label
formats written in either ZPL or ZPL II, eliminating the need to rewrite any
ZPL formats that already exist. See the ZPL II Programming Guide for
more information on the differences between ZPL and ZPL II.
Default: ZPL II
Selections: ZPL II, ZPL
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
Select Media Power-Up Option
This parameter sets the action of the media when you turn on the printer.
Default: CALIBRATION
Selections: FEED, CALIBRATION, LENGTH, and NO MOTION
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the
sensor settings.
• Length—In continuous mode, feeds the last stored label length. In
noncontinuous mode, calibrates based on the maximum label length
setting (see
Set Maximum Label Length on page 78 ).
• No Motion—the media does not move. You must press FEED to
cause the printer to resynch to the start of the next label.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 18 of 23)
Parameter Action/Explanation
ZPL MODE
- ZPL II +
MEDIA POWER UP
- CALIBRATION +