Zebra Technologies Z4Mplus - Manual (Page 25)

17 Printer Setup
Connect the Printer to a Power Source
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
Connect the Printer to a Power Source
The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
Power Cord Specifications on page 18 .
To connect the printer to a power source, complete these steps:
1. Turn the printer power switch to the Off ( O ) position.
2. Refer to Figure 5 . Plug the power cord into the AC power connector on the rear of the
printer.
3. Plug the other end of the power cord into a power outlet near the printer.
Figure 5 • Power Connection
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
1
Power switch
2
AC power connector
1
2