Install memory card – Zebra Technologies Z4Mplus User Manual
Page 73
65
Operations
Install Memory Card
1/18/06
Z4Mplus/Z6Mplus User Guide
13163L-001 Rev. A
Install Memory Card
The printer can use Type I or Type II compliant Personal Computer Memory Card
International Association (PCMCIA) cards.
To install the PCMCIA memory card, complete these steps:
1.
Remove the PCMCIA card shield from the rear of the printer.
2.
Insert the PCMCIA card, with the notch UP, into the card slot as shown (see
Insert the card far enough to cause the eject button to pop out.
Figure 26 • Installing the PCMCIA Card
3.
Reinstall the PCMCIA card shield over the PCMCIA card and card slot.
The printer is now ready to operate with the additional memory or font option.
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
Note •
The PCMCIA card is hot-swappable. It can be installed while the printer is On (
l
).
1
PCMCIA card
2
Notch
3
Card eject button
Note •
Initialization of the PCMCIA card may take a few minutes; the PAUSE LED flashes
while the card initializes. If the card is already initialized, the PAUSE LED flashes only once
or twice. To verify that the card has successfully initialized, print a configuration label and
review it to see if the new memory card information is listed.
F
u
s
e
F
u
s
e
1
2
3