Zebra Technologies Z4Mplus - Manual (Page 90)

Configuration
Control Panel LCD Displays 82
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1. Press SELECT to select the parameter.
2. Press PLUS (+) to select YES .
If your printer is set to require a password, you are prompted to enter
the password.
3. Enter the password. For instructions, see Change Password-Protected
Parameters on page 70 .
The display shows
INITIALIZE FLASH?
4. Press PLUS (+) to select
YES
.
The display shows ARE YOU SURE? .
5. Do you wish to continue?
• Press MINUS (-) to select
NO
to cancel the request and return to the
INITIALIZE FLASH prompt.
• Press PLUS (+) to select
YES
and begin initialization.
When initialization is complete, the printer automatically exits Setup
mode, and the control panel displays
PRINTER READY . If you exit
Setup mode while initialization is still in process, the control panel
display flashes between the phrases
CHECKING E: MEMORY and
PRINTER IDLE .
Note • Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
6. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 10 of 23)
Parameter Action/Explanation
INIT FLASH MEM.
YES