Zebra Technologies Z4Mplus - Manual (Page 101)

93 Configuration
Control Panel LCD Displays
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
These parameters are automatically set during the calibration procedure
and should be changed only by a qualified service technician. Refer to the
ZPL II Programming Guide for information on these parameters.
To skip these parameters:
1. Press PLUS (+) repeatedly.
Adjust LCD Display
This parameter allows you to adjust the brightness of your LCD if it is
difficult to read.
Default: 10
Range: 00 to 19
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value (increase brightness).
3. Press MINUS (-) to decrease the value (reduce brightness).
4. Press SELECT to accept any changes and deselect the parameter.
Select Format Convert
Selects the bitmap scaling factor. The first number is the original dots per
inch (dpi) value; the second, the dpi to which you would like to scale.
Default: NONE
Selections: NONE, 150
→ 300, 150 → 600, 200 → 600, 300 → 600
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 21 of 23)
Parameter Action/Explanation
WEB S. 073
- +
MEDIA S. 075
- +
RIBBON S. 071
- +
- +
MEDIA LED 082
- +
RIBBON LED 008
- +
LCD ADJUST +10
- +
FORMAT CONVERT
- NONE +