Zebra Technologies Z4Mplus - Manual (Page 46)

Operations
Load Media in Peel-Off Mode or Liner Take-Up Mode 38
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
12. Close the printhead assembly.
13.
Close the peel assembly using the peel-off mechanism release lever.
14. In which mode do you wish to operate?
Caution • Use the peel release lever and your right hand to close the peel assembly.
Do not use your left hand to assist in closing. The top edge of the peel roller/assembly
could pinch your fingers.
To operate in... Then...
Peel-Off mode If the printer is paused (the pause light is on), press PAUSE to
enable printing. Peeling starts automatically.
Liner Take-Up mode 1. Slide the liner into the slot in the liner take-up spindle (
1
).
Ensure that the liner is resting against the back plate of the
spindle assembly.
2. Turn the spindle assembly counterclockwise a few times
to snug the liner.
3. If the printer is paused (the pause light is on), press
PAUSE to enable printing. Peeling starts automatically.
1