Zebra Technologies Z4Mplus - Manual (Page 50)

Operations
Load Media in Cutter Mode 42
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
6.
7. Push the media to the back of the transmissive sensor (
1
). Slide in the media guide (
2
)
until it just touches the edge of the media.
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.
Feed the media under the dancer assembly (
1
), through the slot in the transmissive
sensor (
2
—standard transmissive sensor shown), under the ribbon sensor (
3
), and
through the cutter (
4
).
1 2 3 4
1
2