Zebra Technologies Z4Mplus - Manual (Page 95)

87 Configuration
Control Panel LCD Displays
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
Set Protocol
Protocol is a type of error checking system. Depending on the selection, an
indicator may be sent from the printer to the host computer signifying that
data has been received. Select the protocol that is requested by the host
computer. Further details on protocol can be found in the ZPL II
Programming Guide.
Default: NONE
Selections: NONE, ZEBRA, ACK_NAK
Note • ZEBRA is the same as ACK_NAK , except that ZEBRA
response messages are sequenced. If
ZEBRA
is selected, the printer
must use DTR/DSR for host handshake protocol.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Set Network ID
Network ID is used to assign a unique number to a printer. This gives the
host computer the means to address a specific printer. This does not affect
TCP/IP or IPX networks.
Default: 000
Range: 000 to 999
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (-) to move to the next digit position.
3. Press PLUS (+) to increase the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 15 of 23)
Parameter Action/Explanation
PROTOCOL
- NONE +
NETWORK ID
- 000 +