ZyXEL Communications 202H - Manual (Page 102)

Prestige 202H User’s Guide
10-10 Dial-in Setup
10.7 LAN-to-LAN Server Application Example
Your Prestige can also be used as a dial-in server for LAN-to-LAN application to provide access for the
workstations on a remote network. For your Prestige to be set up as a LAN-to-LAN server, you need to
configure the Default Dial-in User Setup to set the operational parameters for incoming calls. Additionally,
you must create a remote node for the router on the remote network (see the chapter on Remote Node
Configuration). An example of your Prestige being used as a LAN-to-LAN server is shown as follows.
Figure 10-8 Example of a LAN-to-LAN Server Application
10.7.1 Configuring Callback in LAN-to-LAN Application
In this scenario, LAN 1 first calls LAN 2, then LAN 2 calls back to LAN 1. These are the respective SMT
menus.