Xerox 4520 - Manual (Page 45)

S e l e c t i n g a P a p e r S o u r c e
C h a p t e r 2 : H a n d l i n g P a p e r ❖ 2-33
For each of the six PCL paper sources ( Figure 2.16 ,
page 2-30 ), a Source Mapping setting from Figure 2.17 is
used. You may change settings depending on your printing
needs. For details, see “Factory-Set Source Mapping
Settings” (page 2-35) , “Source Mapping Examples”
(page 2-36) , and Source Mapping (page 3-22) .
Figure 2.17 Source Mapping settings
Source Mapping
setting
Description
Upper
Middle
Lower
Upper-Middle
Upper-Lower
Middle-Lower
Up-Mid-Low Tray or tray sequence to be used for each
of the six PCL paper sources.
Manual Tray selection appearing when there is no
MBF, HCF, or HCEF installed.
Use this selection to print the first page
of a print job by feeding a single sheet of
paper into the SBF slot before the print
job starts.
MBF Tray selection appearing when the MBF
(page 2-14) is installed.
Source Mapping
Settings
WUG-CH02 Page 33 Black,Red,Cyan Sunday, January 22, 1995 7:32 PM