Xerox 4520 - Manual (Page 118)

T e s t M e n u
3-64 ❖ 4 5 2 0 / 4 5 2 0 m p U s e r ’ s G u i d e
Figure 3.20 describes each Test Menu function. See “Setting
a Menu Option” (page 3-10) for the steps in performing a Test
Menu function.
Figure 3.20 Test Menu functions
Function Description
Config. Sheet Configuration Sheet to show the printer’s current information and menu settings.
The Configuration Sheet contains a variety of information such as:
• Number of sheets printed to date.
• Total printer memory (RAM) available.
• Firmware versions for the printer controller and print engine.
• Firmware versions for Ethernet, LocalTalk, and Token Ring, when installed.
• PostScript revision level, when installed.
• Current menu settings.
• Hard disk statistics, when installed.
• Information on all installed options including the MBF, HCF, and HCEF.
The Configuration Sheet is printed from the Default Source (page 3-21) at the
current Resolution (page 3-27) setting, both specified in the PCL Menu, using A4
(210x297) paper if the System Menu setting for Defaults (page 3-61) is Europe , or
using Letter (8.5x11) paper if Defaults is USA .
Config. Sheet will cause a printer reset.
Demo Page
Note: This option is only
available for firmware
releases 4.06 and higher.
To determine the firmware
release of your printer,
print a Configuration
Sheet.
Demo Page listing Connectivity, Paper Handling, Print Quality and Page Description
Languages of the printer.
The Demo Page is printed from the Default Source (page 3-21), specified in the
PCL Menu, at 600 dpi using A4 (210x297) paper if the System Menu setting for
Defaults (page 3-61) is Europe , or using Letter (8.5x11) paper if Defaults is USA .
Demo Page will cause a printer reset.
Test Menu
Functions
WUG-CH03 Page 64 Black,Red,Cyan Tuesday, March 21, 1995 4:54 PM