Xerox 4520 - Manual (Page 114)

S y s t e m M e n u
3-60 ❖ 4 5 2 0 / 4 5 2 0 m p U s e r ’ s G u i d e
In Figure 3.18, System Menu options and their settings are
described. Factory settings are boldfaced , followed by an
asterisk ( * ). See “Setting a Menu Option” (page 3-10) for the
steps to find and change a setting, or refer to the Document
Services for Printing Guide to use the RUI to change settings.
Figure 3.18 System Menu options showing factory settings
Option Setting Description
Hex Dump Off*
On
Print output as hexadecimal codes instead of normal
print data.
When Off , data is printed normally.
When On , Hex Dump is used for error checking and
error analysis.
When Hex Dump is O n , the Control Panel
menus are not available.
Chime Off
Once*
Continuous
Audible chime signal for attention.
When Once , the printer sounds one audible chime
when needing attention.
When Continuous , the printer sounds frequent
audible chimes when needing attention.
When Off , no chime sound is produced.
System Messages
Note: This option is
available for firmware
releases < 4.06 only. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
Off
On*
Display of system error messages.
When On , system error messages are displayed.
When Off , no system messages are displayed.
System Menu
Options
Note
WUG-CH03 Page 60 Black,Red,Cyan Tuesday, March 21, 1995 4:54 PM